Defender Source Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
1,568 Posts
Discussion Starter · #1 ·
Finally finished the installation of the Protection and Performance cage on my 90.
Installing the seat belts anchor bolts is a problem though

Normally all, at least all Defenders, have UNF 7/16 thread.
THis doesn't fit which surprises me as this is made for a Defender.

It is also not M10 although close. Not M10 x 1.25 either or UNC . WHat other options are there ?

M10 will go through but is very loose and wiggly, I am sure it will snapp the thread when tightening.


As usual, and as almost every UK based Land Rover parts manufacturers, it looks like PP doesn't have customer service; they don't respond to anything.






 

·
Super Moderator
Joined
·
14,153 Posts
If M10 is loose, it must be 7/16". 7/16" UNF is the standard for all car seatbelt anchors.
 
  • Like
Reactions: SadKingBilly
1 - 5 of 5 Posts
Top