Defender Source Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter #1
We are happy to announce that we have replicated the 1994-1997 NAS Defender 90 Soft Top 3rd brake light assembly for retail sale. This NAS specific light assembly has long been obsolete, and is now hand made in Vermont at Congleton Service. This unit includes a lifetime LED unit, and is completely weather-proof. It includes enough of a lead to wire through the factory bar and uses stainless hardware to mount in the factory location.*

In the future, we are hoping to be able to offer the 3rd brake light bar itself.*



This replaces the following part numbers:

AMR3941(less the bar)

STC1631

Available for $399 + shipping through our website below
https://congletonservice.com/shop/nas-defender-soft-top-3rd-brake-light-1994-1997/







 

·
Registered
Joined
·
97 Posts
Discussion Starter #4
Thank you guys, it's been a long time coming. Since these are molds of factory ones, we actually had to use several bad ones(most are at this point) to create one good one. Picking out an LED that looked appropriate wasn't easy either.

The housing is a fiberglass composite. It's two halves that are bonded together and then seem sealed. It takes around 8 hours to make each one!
 

·
Registered
Joined
·
97 Posts
Discussion Starter #9
How’s the bar coming along? Do you have an ETA?


Sent from my iPhone using Tapatalk
No ETA yet unfortunately, have not even seen the prototype yet.

nice work

very close to the original
Thanks Ron, we would have liked to get the light a little more original, but that was near impossible. The housing itself is identical.
 
1 - 10 of 10 Posts
Top