Defender Source Forum banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
702 Posts
Discussion Starter · #1 ·
Hi,knew it one time while installing the bellhouseing but for the world of me cannot find it again.

Bellhouseing bolts to gearbox bolt torque,
felt like in the 55lbs area to me.

Also replacing the input shaft seal is why,what are the torque settings for those 6 on the gearbox input shaft plate?

Have read on how it's done and looked at LR on line manual but haven't seen what to torque them to
Thanks
 

·
Super Moderator
Joined
·
14,309 Posts
LT77?

Clutch housing to gearbox bolt. 48-59 lb-ft
Front cover to gearcase . 16-21 lb-ft

In the front of the manual. Section 06, page 3
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top