Defender Source Forum banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
592 Posts
Discussion Starter #1
Looking to replace my corroded fuel pump connector on my '97 D90. Don't know if this connector is something I can get new or will have to get used, perhaps it's the same connector on a Discovery I? I attached a picture of the connector I need to replace. Is there a part number for this connector?
 

Attachments

·
Premium Member
Joined
·
592 Posts
Discussion Starter #3
Hey Mack,
Thanks for your help, that website led me to what looks just like the connector I need. Trying to figure out if I have a 4 pin or 6 pin connector however. Last time I had the tank down I recall only seeing 4 male spade connectors in the fuel pump connector housing. Here in a better pic of my connector I'm trying to replace it almost looks like there are really only three spade connectors, hard to say without taking it apart, not looking forward to dropping the tank.
 

Attachments

·
Premium Member
Joined
·
219 Posts
That's a four pin the center two holes are a clip to hold the cover on. I buy them from Eastern Beaver. He sells blanking plugs for unused holes or you can pull the blank from your old plug.
 
1 - 4 of 4 Posts
Top