Defender Source Forum banner

1 - 7 of 7 Posts

·
Premium Member
Joined
·
1,494 Posts
Discussion Starter #1 (Edited)
Used but in good condition. Off TD5 bulkhead so you'll need to check/verify fitment on your application. Was saving for my project but decided not to use it $200 pickup in nova(preferred) $225 shipped
 

Attachments

·
Premium Member
Joined
·
1,494 Posts
Discussion Starter #2
Bump. Anyone before it goes back into storage?
 

·
Premium Member
Joined
·
8,968 Posts
Fwiw, these are no-longer-available...and VERY hard to come by in LHD (particularly in this good of condition). They will essentially fit ANY LHD Defender (Td5 or not), you just may have to notch the insulation depending on the location of your bonnet pull. Other than that it's a quick & painless installation process (and significantly cuts down on the engine noise bouncing through the bulkhead and into the passenger compartment).
 

·
Premium Member
Joined
·
1,494 Posts
Discussion Starter #6
Sold last night and funded today. Thanks D90.
 

·
Premium Member
Joined
·
11,911 Posts
Fwiw, these are no-longer-available...and VERY hard to come by in LHD (particularly in this good of condition). They will essentially fit ANY LHD Defender (Td5 or not), you just may have to notch the insulation depending on the location of your bonnet pull. Other than that it's a quick & painless installation process (and significantly cuts down on the engine noise bouncing through the bulkhead and into the passenger compartment).
I have a set. Brand new in package. Been holding out for a new center piece that doesn't have the cut out to trade.
 
1 - 7 of 7 Posts
Top