Defender Source Forum banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
33 Posts
Discussion Starter #1
the prototype SVC/Cameron Concepts Supercharger kit for a Disco2. should fit SAI if you flip the drivers side pipe/solenoid valve over and reroute the air tube. May fit a P38 but this was supposed to fit a D2. This is the only one known to exist as it was sold off after Cameron passed away.

For BOSCH intake manifold. no reason it cant be made to work on a defender with that.

Similar to this: Range Rover Power & Drivetrain Upgrades
7lbs boost IIRC
Eaton M90 Short Snout (rare)
SplitSecond 9th/10th injector controller, land rover guy told me years ago that the factory fueling would hold 5lbs of boost

The idle bypass valve has a broken nipple, but they are 40 or so from summit for a new one. I have most everything else to install save for any small hoseclamps or hardware. I never installed it.

This is the prototype so it has a few rough cast pieces.

I sold off my rovers and I don't think my mom wants this on her D2....
***I never ran this but I did mock it up most of the way years ago.

$1000 shipped. OBO. I'm in it for $1200:(
 

Attachments

·
Premium Member
Joined
·
33 Posts
Discussion Starter #3
Lots of interest but no takers so far.

A lot of people have asked how it sits on the engine, it sits off the drivers side of the engine, about even with the top of the intake manifold. No or very little hood clearancing is needed for a d2. Not sure on a defender but would imagine about the same.

I'm open to reasonable cash offers.
 
1 - 4 of 4 Posts
Top