[NateB]

Thanks, I’m having lots of fun. Any suggestions on the heat shield? I got the tank from Jason at Series Defender

 

[NateB]

Front sway bar installed!

 

[NateB]

Stock Rear prop shaft is about 3.5 inches short

 

[NateB]

I’m shocked….. no one said that’s what she said…..

 

[NateB]

X disc hand brake powder coated and installed

 

[NateB]

Rear fuel line mounted and secured to frame.
Fuel pump swapped and new lines inside pump installed

 

[NateB]

Rear prop shaft added length and installed

 

[NateB]

Looks great, I have a big tank on mine and I've been wondering what to do for a rear sway bar since it hangs down below the mounts. Have you thought about that yet?

Still love that frame lol.

Sean

so Sean, you were right… it did not fit. I found a 1 inch spacer from lucky 8 . Works great!

 

[roadworn]

Thanks, I’m having lots of fun. Any suggestions on the heat shield? I got the tank from Jason at Series Defender

These are the covers that came fom Nick. You could easily make some.

 

[NateB]

Oh, I do have those, I didn’t realize what they are for…… I hadn’t seen anyone using them

 

[NateB]

Harness ran through chassis

 

[NateB]

Motor mount covers installed. (I’m an idiot and first tried to install them the wrong way….don’t ask)

 

[NateB]

Today I got my welder all setup to tig. I’m going to build my exhaust out of some stainless steel pipe while learning to tig for the first time….. should be exciting. Stay tuned!

 

[sgo70]

https://www.youtube.com/@PacificArcTigWelding

That's a new series I really like for tig welding, I might even do his course one day.

Sean

 

[NateB]

Hey thank you. I’ve been watching lots of videos and will check this out. If I get stuck or they turn out like crap, I was gonna ask for your advice

 

[sgo70]

Haha, all I know for sure is if it’s working, don’t stop. Same if it’s not, come back the next day lol.

Sean

 

[NateB]

Got a little bit done today. Started mounting the new bulkhead. I welded shut the vents , turned out pretty nice.