Defender Source Forum banner

Clutch slave bracket install?!

1K views 1 reply 2 participants last post by  LRover 
#1 ·
Hi everyone!

I just swapped a 200tdi into my 109 but am having trouble bolting the bracket which houses the clutch slave cylinder onto the transmission! Its pretty tight and am not able to move it close enough to get the bolt on it. Are there any tricks to get this on or do i possibly have an issue preventing me from getting this installed?

456245


Thanks in advance!
 
See less See more
1
#2 ·
It's hard to tell from your picture but it looks like you have another issue. You should have about an inch clearance between the bulkhead and the bracket as the transmission should still be in it's original position as when it was installed with the original motor. Check your transmission mounts if it was pulled and check the motor mounts to make sure they aren't pushing the drivetrain sideways.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top