Defender Source Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 500 Results
  1. Wanted
    Looking for one that has jerrycan holders and trailer hitch.
  2. Wanted
    looking for a set of wings, prefer 300TDI or later with the indicator cutouts. Alternatively, easier enough to pull them off and replace the outer skins? Cheers
  3. Pre - 2016 Defender Technical Discussions
    I'm looking to fit a swing away tire carrier to an NAS 90 SW. Britpart have one VPLDR0130, but it states only steel rims. This truck has 5 alloys and I dont want to have to swap for a steel spare rim. Will a wheel spacer allow the wider rim to hang? I'd appreciate anyone's input. Thanks
  4. Wanted
    Looking for a used right hand wing for a ex mod 110 to fix my winter romp damage. Thanks Guys!
  5. Pre - 2016 Defender Technical Discussions
    I had an interesting thing happen last week. I was putting my 86 D90 onto a tow dolly to take it over to a maintenance shop (Black Hawk Customs here in Aurora Colorado). It rolled fine out of the garage and up the ramps so that the front wheels were on the dolly. Once it was secured to the...
  6. Wanted
    gday folks, Looking for a pair of used wingtop chequer plates before i go sort newer ones out. Bonnet plate would be good as well.
  7. For Sale - Parts
    Multiple Land Rover Defender 90 NAS parts Diamond Plate Wing tops Defender 90 Sills Reflectors Air filter Skid Plate Soft Top Hardware Front seats roof rack cage mounting hardware Center Console plastic holder Door card screws Jacks - 2 different LR jacks and bars Roll bar cage pads
  8. Wanted
    I'm on the lookout for the right front wing assembly of a defender 90/110.
  9. For Sale - Parts
    This is a bumper I purchased new from RTE Fabrication. It has a custom swing away with a double-sheer joint, tire carrier and 2 jerry can holders. The carrier was built by Tim Scully. The side wings have also been replaced with stronger pieces as the original ones were a little flimsy. This...
  10. For Sale - Parts
    New still in original package, Genuine Land Rover Defender Soft Top Mantec Swing Away Spare Wheel Carrier, $500 plus shipping. These are designed for steel wheels, you may require a wheel spacer to use with alloy wheels
  11. Pre - 2016 Defender Technical Discussions
    I have my 84 110 defender in the body shop getting a long overdue tidyup and paint job. My body man thinks that it might be more cost effective to replace the right wing and both left and right wing tops as compared to his hourly rate to straighten and repair.What is the quality of the body...
  12. Pre - 2016 Defender Technical Discussions
    Is it worth figuring out a better option to the regular flex hose that runs from the wing vent to the air box? I was wondering if a straighter smoother run would be beneficial I switched the hose that runs from the air box to the turbo, from stock to silicone, and did notice a bit of a...
  13. Pre - 2016 Defender Technical Discussions
    Has anyone used the ABS Plastic Outer Wing Skins? I noticed them on a few sites and was wondering what they were like, any painting issues with the ABS against the Aluminum top wing skin, etc.
  14. Pre - 2016 Defender Technical Discussions
    Just spent the weekend towing our camp trailer, and Andrea and I were discussing a larger trailer, tow vehicles and what can we tow. I was wondering if a stock 110 can pull whatever gvw Rover says (7700#?), if one Fitz disc brakes to the rear, higher rate springs and gas charged shocks, could...
  15. Pre - 2016 Defender Technical Discussions
    I checked the temp on the block and hoses. Seems high. I'm far from being an expert. Note: brand new hoses, water pump, thermostat, and radiator. She runs perfectly when idling. Won't leave center gauge all day. Creeps near orange zone on highway after 15 minutes. Thanks all...
  16. Pre - 2016 Defender Technical Discussions
    So about a year ago I jacked up my switch assembly when attempting to fix my ignition switch. Basically I broke the arm and my assembly went limp and wouldn't support itself in the normal position. So I purchased PLF346 a proline version that is $70 compared to $250 genuine from Rovers North...
  17. Pre - 2016 Defender Technical Discussions
    I've got an '84 Ninety and I've updated her to house a 300Tdi / R380 (woohoo!). As you know, the 300Tdi needs a different air intake configuration. The standard practice is to use a side vent, but I'm not keen to cut more holes in the body-work, mess with the paint, etc. Besides, this would...
  18. For Sale - Parts
    A set of wing tops for sale. Used, in great shape. Asking $45.00 + shipping.
  19. Wanted
    Looking for oem nas side steps, nas front bumper and A bar (for 97 with ac if that matters). Longer shot - also interested in a Coniston passenger side wing/fender in very good condition, again for 97. Have Southdown steering skid that could be used as partial currency. Thanks
1-19 of 500 Results