Defender Source Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 160 Results
  1. Pre - 2016 Defender Technical Discussions
    Hello Dear Gentlemen; Would you tell me how I can connect the PRC 7925 (Range Rover Classic Sensor Low Level Coolant) to my Tdi 300 (1998 model Td5 dash board). I found some explanation on internet but İt is needed to have or to build some interface such as relay, resistor (electronical...
  2. Pre - 2016 Defender Technical Discussions
    Our 97 NAS Defender occasionally stalls while driving. A generic shop cleaned the MAS and it's not stalling now. However, it's idling around 1200-1300 RPM. They said the cold air sensor is registering a -15 degrees so it is probably bad. Problem is they can't source this part and I am not able...
  3. Pre - 2016 Defender Technical Discussions
    While under the hood, I noticed that both the wires going to the low-brake fluid sensor cap in the master cylinder reservoir had corroded and broken off. Oddly - the brake warning light wasn't on. It does illuminate for a few seconds when turning on the ignition as expected. I fixed the...
  4. Pre - 2016 Defender Technical Discussions
    1997 NAS D90. Did not find anything from the search results. If I missed it, sorry in advanced. Anyone have good experience with non-OEM oxygen sensors? Our D90 is in the shop and they can only find one OEM sensor locally without going to the dealership. Would it be safe to get a Denso, Bosch...
  5. Pre - 2016 Defender Technical Discussions
    Ok, here's a mystery for the group... I replaced the front exhaust pipe section (y pipe through cat converter) with an NRP piece from RN about a year ago. This was connected to a stainless "cat back" rear pipe. Now the entire pipe is stainless. I replaced the O2 sensors while we were at it...
  6. Pre - 2016 Defender Technical Discussions
    Gents, I'm trying to resolve a P0327 code on my 1997 D90. I've replaced the knock sensor on the driver's side already. But I'm still getting the code. The next thing is to replace the wire and connector possibly. I'm hoping to avoid running new wires since both wires are part of the engine...
  7. Pre - 2016 Defender Technical Discussions
    I replaced my 2.5TD with a Discovery 200Tdi. The 2.5TD had two sensors on the oil filter assembly but the Discovery 200Tdi only has one. Is the sensor on the Discovery 200Tdi the oil temperature sensor or the pressure sensor? Which wire should be connected the this sensor? I have...
1-7 of 160 Results
Top