Defender Source Forum banner
1-16 of 127 Results
  1. Wanted
    Looking for defender door seals set for a 110. Need for my 109 build
  2. Defender Technical Discussions
    Compiling a list of all exterior seals and strips for my 90. The PO was nice enough to color match almost all of them on the car wash respray. Needless to say they are all pretty chewed up, dried out, or simply missing. Here is my list so far, not sure what else I missed. All numbers showing...
  3. Wanted
    I'm trying to source replacement sunroof seals for my late 80s 110 which seems to refer two parts: MWC9500 and RTC5942 And, of course, both of these parts appear to be NLA. Does anyone have a source for them or solutions short of gluing the sunroof shut? I've got the latch-type sunroof...
  4. Wanted
    This is my last hope to get my front doors sealed/aligned. Have new Britpart seals, but they aren't cutting it.
  5. Defender Technical Discussions
    Dear Abby: I spent hours lining up all of my panels so that doors, a / b / c pillars lined up well with good panel gaps. Sills matched up nice. Then.....I added my new door seals and it all went to hell. What's going on? Door won't shut well at all. Do I need to just be patient for a few...
  6. For Sale - Parts
    2 new Alpine windows + all 4 seals. Asking $140.00 + shipping.
  7. For Sale - Parts
    I have 2 New tailgate door seals part number: CKE101101 Price:$20 each shipped to CONSUS or Both for $35 shipped to CONSUS
  8. Defender Technical Discussions
    Curious if anyone has run into the same problem I'm facing now: The new door seals (pre-formed single-piece ones, covering top and sides) I bought for my 1988 110 seem to be designed for wider door openings. Installed as is they don't fit by about 3/4" on both the front and second row doors...
  9. For Sale - Parts
    Here is a pair of the one piece door seals for the early Defenders. Note the notch for the windscreen area. They are new ... I never used them. I think they will also fit Series vehicles as a nice upgrade to the crappy, after market glue-in seals. $125 for the pair and buyer pays the ride.
  10. Defender Technical Discussions
    Anyone have a set of these I can buy or borrow? Or a place to buy them. Thanks
  11. Smaller Projects
    I have done quite a bit of reading on this but am still confused as hell. I have a 1991 ROW 110. My vent seals are shot and need to be replaced. I pulled one of my vents off and pulled out the seal. Someone sent me a set of seals and it is part number 330621. These are light grey in color...
  12. Defender Technical Discussions
    Another case of not enough documentation and too much time lapsed. I've dug around online and here and can't really find this info. Anyhow I hope to be installing my freshly painted roof tomorrow on my '97 110 CSW(weather permitting) and am after a bit of info in regards to the roof seals...
  13. For Sale - Parts
    Gently used aftermarket RH (CFE102981 / LR044307) & LH (CFE102991 / LR044308) front door seals, on vehicle for ~7K miles (approx 1 year). Thought these were the source of my water ingress so replaced with genuine seals, turns out it was *actually* my windshield seal that was the culprit...
  14. Defender Technical Discussions
    The door seals I had needed to be replaced, and the sill underneath repainted. These were the straight seals that rivet to the bottom of the sill, not the door itself. Is this what I want for replacement? ALR6250 I ask, because when you look those up, you get pics of what looks right, but also...
  15. Defender Technical Discussions
    Hello all. New guy here. Just purchased a 1985 LR90 2.5 NA with bad oil leak. I thought I would try the t-seals before I attack the rear main seal. Can't seem to find the seals listed for the 2.5 anyplace. They are not shown on any engine breakdowns I have found. I assume I will need main...
  16. For Sale - Parts
    I have a new complete set (top, bottom, both sides) for a Disco I. $300 shipped.
1-16 of 127 Results