Search Results for ‘edelbrock’

Have a 3.5 v8. Going to replace my SU carb set up with the Edelbrock 500 carb and 2198 manifold. Anyone use this type with the automatic choke? Or, is it best to stick with the manual choke. How difficult is it to set up the automatic choke vs manual?

Hello all, I am looking to upgrade to an edelbrock manifold and carb soon from the stock carbs on my 3.5 v8 but would like to keep the propane system working. Does anyone know where I can buy a mixer for the edelbrock 1404 here in the states? Something like this one produced by RPI...

Was wondering if anyone else is using an Edelbrock 1403 or 1404 carburetor on a Rover 3.5 engine and what they have found as the best Metering jets and and metering rod set up ?

I have done quite a bit of searching on D90 and elsewhere and I have not been able to find a good source that covers setting up all the vacuum/breather lines for an edelbrock carb as a replacement for a stock twin carb setup. I have seen a number of photos of the setup and they all seem to vary...

The previous owner of my 110 V8 installed a Weber/Edelbrock intake manifold and carb kit from RPI. He did not, however, install the choke cable. The Edelbrock instructions for connecting the choke cable to the lever are not very explicit, and I have dug through the internet in search of the...

Has anyone replaced their hotwire EFI with an edelbrock setup? I’m looking at doing this as I’m having problems with the hotwire and getting it to run on my project 90. I plan on the export the US next year when it is 25 years old. http://www.rpiv8.com/carbs-1.htm#installation