Search Results for ‘drain plug’

I'm getting ready to install the safari-quip extended range fuel tank and is there a drain plug or do I just need to run it out of fuel?

I just replace the slave on my 1988 d 110 rt77 As I refilled the master cylinder and started the bleeding process I noticed the clutch pedal was not building up pressure. I noticed then that fluid was now leaking out the bottom of the clutch housing. (see pic) I hope this is a drain...

Can't find the info on this in the manuals so I thought I'd ask here. On a 300 TDI the block located coolant drain plug has a profiled copper crush washer. Which way should the washer be oriented in relation to the bolt? Or does it matter? Two ways washer could be installed illustrated...

Bought No-Spill's plug system and they sent me the wrong size thread. It's coarser than the plug on my 300 tdi. NOW they want me to pull it (anybody see what's happening next?) to measure it for them. read somewhere on a brit forum that it was 13/16 (20.5mm) head with 14tpi bsw. Does that...

so about a 2 months i was doing a pre-trail inspection on my brothers 110 and i noticed the drain plug on the tranny was missing. it must have been missing for at least 4k miles because thats when it started to pick up a bit of a grind going into 2nd and 4th. so anyways after a month of waiting...

Hello all, I want to install an EZ drain or Fumoto oil drain valve. The Defender is too old to come up on the Fumoto site. I ordered the EZ drain valve as spec'd for the Defender on the EZ Drain site, but the valve they spec'd is incorrect. Can someone please tell me the correct size of the...

I tried to remove the transmission drain plug with a wrench but is will not turn. I was able to remove the filler plug and the strainer plug. Any ideas on how to remove the drain plug?

Just curious if I need to get a cooper ring for the 380 drain plug similar to when I changed the engine oil?

Doing some work on the truck and decided I would swap the fluid in the t-case...put a wrench on the drain plug, turned and it was really easy but didn't really come out at all. I don't remember overtightening on the last install but the plug was definitely broken. I got a small flat blade...

As I was addressing my steering headache. I noticed, I am missing two drain plugs!!!???? Anyone know what purpose?

I've been thinking of a substitute for that very weak part and I've this in mind: http://www.mcmaster.com/#thumb-screw-fasteners/=d8cbww You can cut the slot with a dremel cutting wheel The original part number is 37H7920...

So undergoing changing all my gear oil over to royal purple on saturday, and saved the transfercase for last. I had drained, cleaned, filled, and refitted the drain plug hand tight, and then got out the torque wrench set to 23 lb-ft. Tightening, went to first click, released, eased into it...

Before I shell out cash for a socket, does anyone know the correct size for the engine oil drain plug? That damn thing is on there good & will need some muscle. Thanks!

I have a new to me 90 and changed all the fluids today. This brought about one problem. I removed the transfer case drain plug. It was neither unusually hard or easy to remove, seemed quite normal. Once removed, I noticed metal coils stuck in the threads of the plug. On re-install the plug...

Are the front/rear diff drain plugs the same size/thread as the transfer case drain plug? I want to replace all three with a magnetic drain plug FTC5208G from AB. Cheers...

I need to change my oil of my swivel housing to one shot, but where is the drain plug for it? I stupid q's, but i dont see it. Thanks