Defender Source Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

41-43 of 79 Results
  1. Pre - 2016 Defender Technical Discussions
    Has anyone had a bulkhead galvanized lately? What did it cost you? I've searched the threads for an idea of the cost of getting the bulkhead hot dipped but haven't found much on what folks have been paying to have it done. I know prices vary depending on location and area.
  2. Pre - 2016 Defender Technical Discussions
    After installing the Puma seats in my 110, the bulkhead really needs to be cut out so I can move the seats back. However, I have a Safety Devices roll cage on the truck that mounts to the bulkhead... What are my options here?
  3. Pre - 2016 Defender Technical Discussions
    Most of you are familiar with the large air box of the 3.5l that is mounted above the bell housing against the bulkhead. Do you think cutting the bulkhead to allow an in-dash ac evaporator to pass halfway into the engine compartment (and then fully steel boxed and air inlet passage cut) would...
41-43 of 79 Results