Search Results for ‘bulkhead’

Just wondering if anyone knows what these stickers denote? They appear to have parts numbers on them (MTC, MUC, etc), but in googling the numbers, nothing comes up. Paint color, perhaps?

Going to be putting the windshield back onto the bulkhead. Got a new seal was wondering if I should apply anything else on there against water leaking in. I have this stuff Ive used on my boat called Bed-it tape, gummy stuff...not sure if this would be a good thing to add onto the backside of...

My progress with the bulkhead repairs....some structure damage due to rust, cut and made new pieces, grinding..cutting..welding...not hard just time consuming...finally fit the panel and today finished welding it in. I'll fill the voids with JB weld. I prefer using this than bondo, easier to...

Need to replace these...after repairing my bulkhead...there were no gaskets actually. Are these made of paper or rubber? Something I could make if I knew the material. Seems a bit high paying 8 bucks for these from some of the vendors I see

trying to locate these or just make my own. Dont have the originals so not sure if they are rubber or paper. Cant see paying 8 bucks plus for these. Anyone know what they are made of?

In the middle of cutting out the rust and bondo mess the PO left me on the areas around the vents...driveres side seems good but passenger side is a mess...down to the door hinge area. I'll have to improvise a bit here and there but the repop panel will hopefully fix most of the issue. My...

I am working on repairing the top corners on my bulkhead. I have the outer skin to replace where the hole that was there. but while taking off the top corner I found that the rust has gone all the way thru to the inside lip of the dashboard corner. is there a replacement part for this too? I...