1992 Defender 90 200Tdi/LHD - Defender Source
Defender Source  

Go Back   Defender Source > Classifieds > For Sale - Vehicles

Thread Tools
Old June 5th, 2019, 11:53 AM
Status: Offline
Land Rovers
Join Date: Jan 2017
Location: USA
Posts: 49
1992 Land Rover Defender 90 with factory LHD and 200Tdi (11L)
Approximately 218,100km (135,500 miles)
Imported in 2017 from Gibraltar, lived its life in Spain. I have been the only owner in the USA.

Asking $35,000. Truck is in central NJ.

PM me with questions, would be happy to talk.

Clean and clear NJ title, heritage certificate and import documentation.

Panel on repaint by seller in Europe prior to sale in original Portofino Red. Solid frame and bulkhead with exception of patch needed on upper surface of passenger side front outrigger. Runs and drives well, stops straight, tracks straight. Optilube XPD in every tank of diesel. Starts well in freezing conditions. Good heat and leaks surprisingly small amount of water in the rain. All electrics/lights work on the truck. Garage kept. Two sets of keys and spare third door lock/fuel cap key. All doors are so/so.

Items on my to do list for the truck are to patch upper surface of passenger side outrigger.
Replace Alpine seals
Rear A frame is getting new bushings and 45 degree ball joint this weekend.

Parts included in sale:
Spare 200TDI Cylinder head
Garrison sliding window kit (will install time permitting)
Spare Rocker shaft and arms
Spare set of mismatched front seats, (backs on frames, bases and headrests)
Genuine alpine window seals.
Rovers North radiator block.
Box of miscellaneous spares, gaskets/seals/hardware/etc.
Boost gauge with vacuum line and tee piece installed.
Masai front light bar

Below is a list of every maintenance item and part replaced on truck in the last 24 months and 2500 miles since import: Most everything is sorted.

Rebuilt 200Tdi cylinder head
Surfaced and pressure tested. Cleaned. New valves, new valve stem seals, new valve springs and caps. All head rebuild parts from Turner in the UK. Tappets set and reset/checked after 100 miles.

New Garrett TB02 Turbo Charger, ETC8751
New Air filter to turbo hose
New exhaust manifold to turbo and turbo to elbow gaskets
New Hardware
New Studs
New Turbo oil return line to sump

New Ashcroft R380 Stumpy
New Ashcroft 1.4 LT230 with sleeved casing, heavy duty cross pin and correct diff-Lock Linkage, new shift lever knobs for both
Clutch, pressure plate, throw-out bearing, release lever, flywheel bushing/pinion
Clutch master and slave

Front and Rear prop shafts
Rubber boot on parking brake drum

New Radiator and hoses, silicone t-stat to heater core hard line hose
Allisport Uprated intercooler
Silicone Intercooler hoses

Elring 3-Hole head gasket along with all upper engine gaskets/o-rings (valve cover/conical seals/half moons/etc), new head bolts all from Turner in UK.
Cam Belt and Tensioner
Bearmach soft engine mounts
Water Pump
T-Stat and gasket
Water temp sender and gauge
Cyclone Breather, cyclone breather hose to air filter
Fan Clutch
Glow plugs(Delphi)
Lift pump (Bearmach) and gasket
Injector to injector return lines and injector to injection pump spill rail line with Bel metric braided rubber hose
Air Filter
Fuel Filter
Belts, alternator and power steering
New 75 amp alternator and genuine pulley

Steering box adjustment, lower steering U-Joint
Steering arm

Genuine Steering Damper
Genuine Standard duty springs
Genuine Shocks
Various Genuine bushings underneath during suspension overhaul where needed
Swivel balls/seals
All wheel bearings and hub seals

Three most aft rubber exhaust hangars

Wiper Wash bottle cap

Front rotors/pads/calipers
Rear drums/shoes/springs/wheel cylinders/rear brake lines
Brake master/gasket

New Battery Feb 2017
Battery negative cable, Battery tie down, J bolts under seat
Fuel tank to filler neck vent house and clamps

Wiper motor park switch
12 volt plug in cabin
Hazard light switch

All fluids are fresh:
Engine: Rotella 15w/40, Mobil 1 301A Filter
R380- Redline MTL
LT230- Redline 75w/90
F/R Diffs- Valvoline 75/140
Clutch/Brake- Castrol
Power Steering- Valvoline ATF/Lucas Additive
Coolant-50/50 Prestone
Swivels- LR one shot

5 New White Wolf Wheels, New General Grabber AT2, 235/85/16, spare not size matched yet
Wheel nuts

Bearmach rear tire carrier

Raptor coated new front bumper with rubber end caps
Raptor coated new rear cross member with rear step
Raptor coated new Rovers North sliders with tree bars
Frame rails internally coated with Eastwood internal frame coating
Externally, frame sprayed with WD-40 twice per year

Four Genuine wheel arches in black

ORE steering guard

Mammouth black chequer plate, wing-tops only
Mud UK snow cowl

All exterior lights:
Hella Vision Plus Glass headlights
Wipac LED kit with proper relay and RDX turn signal LED bulb with ground for proper signal operation
Reverse Light/Rear Fog Light
New rear reflectors

Bulkhead vent seals and stainless steel pins
Bonnet to bulkhead bushings
Stainless hood hinge bolts and nuts

Front and rear mud flaps including mounting brackets and stiffeners
Front outrigger mud guards

Front door seals
Lower waist seals, inner and outer front doors
Rear door seal including rear doorsill finisher piece
Windscreen seal
Bonnet to bulkhead seal
Bonnet to bulkhead rubber bumpers
Pedal box gasket
Upper and lower windscreen hinge gaskets
Sliding window felt
Rear door latch seal and new lock cylinder

Genuine Tdi and Defender 90 decals, rear LR Oval
Reproduction Defender side decals

Front Grille with new LR Oval and stainless hardware
Front light surrounds with stainless hardware

Front and rear wiper arms
Front wipers
Front Windscreen Washer Jet, both pieces

Heated rear window installed to replace non-heated glass, new metal trim and grounding wire

Pedal Rubbers
Instrument stalks, wiper and turn signal
Genuine rubber floor mats along with 2 sets of spare rubber Exmoor Mats
Exmoor Cubby box, locking/grey vinyl
Exmoor Tunnel Cover
Exmoor seat box covering and corner protectors
Mismatched seats covered with Knightsbridge Overland Seat covers (set of spare front seats included with sale)
Genuine forward tunnel cover, lower dash cover insulator
Genuine dash top with coin holder to replace ash try, Defender Demister vents
Genuine headliner installed, three pieces, new style courtesy lights front and rear, roof lined with 1/8” foam insulation
Sound deadening on various interior panels
Genuine parking brake rubber boot

Raptor UK metal instrument Binnacle mount
Raptor UK metal instrument binnacle
Instrument bulbs, warning/advisory light bulbs

Steering column shroud blanking plug

Genuine rear load space rubber mat
Bearmach rear door panel, grey (small crack in panel)
Rear door grab handle
Rear door lock latch spring
Bulkhead storage net

Left and Right kick panel trim replaced, brackets removed: stripped and painted
Door courtesy light switches

Left and Right Door lock guides, Splash shields, door lock estucheons, window winder caps
Multiple door panel clips and snap sacs
Left and Right door strikers, spacers
Rear door striker

Mobile Storage Solutions rear storage chest on r/h foot well

Battery box grommets

Series-Defender driver door armrest

Factory jack and tool kit roll, Owners Manual in Spanish

Link to gallery with videos.

Attached Thumbnails
Click image for larger version

Name:	DSC_1586_DxO.jpg
Views:	204
Size:	720.5 KB
ID:	420176   Click image for larger version

Name:	DSC_1592_DxO.jpg
Views:	178
Size:	683.4 KB
ID:	420178  

Click image for larger version

Name:	DSC_1609_DxO.jpg
Views:	182
Size:	659.9 KB
ID:	420180   Click image for larger version

Name:	DSC_1548_DxO.jpg
Views:	176
Size:	602.3 KB
ID:	420182  

Reply With Quote
Sponsored Links
Old June 7th, 2019, 02:46 PM
Status: Offline
1992 D90
Join Date: Feb 2018
Location: Northern New Jersey USA
Posts: 1
Is this truck still available, i saw this on craigslist but the ad dissapeared, im in Northern NJ
Reply With Quote
Old June 7th, 2019, 02:50 PM
Status: Offline
Land Rovers
Join Date: Jan 2017
Location: USA
Posts: 49

It’s been on and off CL
Reply With Quote
Sponsored Links
Old June 8th, 2019, 09:27 AM
Status: Offline
Land Rovers
Join Date: Jan 2017
Location: USA
Posts: 49
A-frame upper end link bushings and 45 degree ball joint fitted with new hardware this morning.

Will try to get Garrison sliding window kit installed this weekend.
Reply With Quote
Old September 17th, 2019, 12:54 PM
Status: Offline

Join Date: Sep 2019
Posts: 13
how's the rust?
Reply With Quote
Old October 22nd, 2019, 03:45 PM
Status: Offline
John Nell
2002 P38
Join Date: May 2019
Location: Charlotte NC USA
Posts: 1
Still available?
Reply With Quote

Lower Navigation
Go Back   Defender Source > Classifieds > For Sale - Vehicles

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

All times are GMT -5. The time now is 12:21 PM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.

Search Engine Friendly URLs by vBSEO 3.6.1