Defender Source Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 127 Results
  1. Pre - 2016 Defender Technical Discussions
    Compiling a list of all exterior seals and strips for my 90. The PO was nice enough to color match almost all of them on the car wash respray. Needless to say they are all pretty chewed up, dried out, or simply missing. Here is my list so far, not sure what else I missed. All numbers showing...
  2. Pre - 2016 Defender Technical Discussions
    Dear Abby: I spent hours lining up all of my panels so that doors, a / b / c pillars lined up well with good panel gaps. Sills matched up nice. Then.....I added my new door seals and it all went to hell. What's going on? Door won't shut well at all. Do I need to just be patient for a few...
  3. Pre - 2016 Defender Technical Discussions
    Curious if anyone has run into the same problem I'm facing now: The new door seals (pre-formed single-piece ones, covering top and sides) I bought for my 1988 110 seem to be designed for wider door openings. Installed as is they don't fit by about 3/4" on both the front and second row doors...
  4. Pre - 2016 Defender Technical Discussions
    Anyone have a set of these I can buy or borrow? Or a place to buy them. Thanks
  5. Smaller Projects
    I have done quite a bit of reading on this but am still confused as hell. I have a 1991 ROW 110. My vent seals are shot and need to be replaced. I pulled one of my vents off and pulled out the seal. Someone sent me a set of seals and it is part number 330621. These are light grey in color...
  6. Pre - 2016 Defender Technical Discussions
    Another case of not enough documentation and too much time lapsed. I've dug around online and here and can't really find this info. Anyhow I hope to be installing my freshly painted roof tomorrow on my '97 110 CSW(weather permitting) and am after a bit of info in regards to the roof seals...
  7. Pre - 2016 Defender Technical Discussions
    The door seals I had needed to be replaced, and the sill underneath repainted. These were the straight seals that rivet to the bottom of the sill, not the door itself. Is this what I want for replacement? ALR6250 I ask, because when you look those up, you get pics of what looks right, but also...
  8. Pre - 2016 Defender Technical Discussions
    Hello all. New guy here. Just purchased a 1985 LR90 2.5 NA with bad oil leak. I thought I would try the t-seals before I attack the rear main seal. Can't seem to find the seals listed for the 2.5 anyplace. They are not shown on any engine breakdowns I have found. I assume I will need main...
1-8 of 127 Results
Top