Defender Source Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 500 Results
  1. Pre - 2016 Defender Technical Discussions
    Truck is a 1995 NAS V8 with just over 100k on the clock. Has been running great until the other day when I experienced a loss of power and backfire/pop out of the intake when modestly accelerating away from a stop. Off the throttle, the engine immediately returned to a smooth idle. I was able to...
  2. Pre - 2016 Defender Technical Discussions
    Good morning All, Has anyone recently changed the body side capping on their NAS Defender? I bought an original replacement and when installing it, realized the “lip” containing the holes for the rivets are offset by 1/4 inch. Below you will find pics of the original (green) and new (grey)...
  3. Pre - 2016 Defender Technical Discussions
    I am putting my 3.9V8 back in my 95 NAS D-90. I can't figure out where this one vacuum line attaches. Can anyone look at their vehicle and tell me where it attaches? It is typically turned down. It is Tee'd off of the Crank case Vent pipe but there is nothing near by to connect to and my...
  4. Pre - 2016 Defender Technical Discussions
    I need some help! The foam rubber which surrounds the roll cage is wearing/crumbling away at the bottom, where the roll cage bolts to the body. Can anyone suggest ideas for repair? Thank you in advance!! Rob See pics! Thank you in advance!!!
1-4 of 500 Results
Top