Defender Source Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 356 Results
  1. Pre - 2016 Defender Technical Discussions
    The fan speed selector on my 97 is very stiff, it does not move easily. It's been that way since I've owned the truck but it's worked. Recently it's been even more difficult to slide up and down and now the high fan speed only works after fiddling with the lever - moving it side to side a bit...
  2. Pre - 2016 Defender Technical Discussions
    Ok, we are all friends here, right? And I'm soooo not a mechanic (I sell software). Anyways, many of you have been very helpful helping me identify my overheating issues. I think I may have a clue worth sharing. This photo is of the fan switch, right? Mine has NOTHING connected to it. In...
  3. Pre - 2016 Defender Technical Discussions
    I replaced the front cover with a bearmach unit last summer when doing some other work. Not many miles on it since then. I’m in the area again doing the p gasket I noticed it doesn’t see to rotate very true. I put the dial gauge on the rim of the flange where the pulley sits and I get about...
  4. Pre - 2016 Defender Technical Discussions
    Did the fan switch on the dash ever change from the top position being off to the bottom position being off?
  5. Pre - 2016 Defender Technical Discussions
    Yes, I've searched and all I can find is how to determine good or not. Is there a step-step-guide out there on how to replace the fan clutch? I've ordered a replacement clutch and the wrench from Zack but would like some guidance before I start into this. 95 NAS Wagon btw Thanks Board!! KCD
  6. Pre - 2016 Defender Technical Discussions
    About 18 months ago I replaced my viscous fan clutch (LR genuine part) and it has failed... I was told from where I bought it, that there was a "bad run" of fan clutches ....and it's covered under warranty for one year only and I was out of luck. Seems like a bad deal all around for me...
  7. Pre - 2016 Defender Technical Discussions
    The truck has sat for a few months (yet engine has been run)....went to for a short ride around the corner and lost the Belt...broke in half, but also lost some teeth on the belt....fan spins freely...what else is on that belt...(Fan, Alt...?) to ensure that something isn't seized..does the...
    fan
1-7 of 356 Results
Top