Engine Storage - Defender Source
Defender Source  

Go Back   Defender Source > Defender & Series Technical Discussions > Defender Technical Discussions


Reply
 
Thread Tools
  #1  
Old November 17th, 2008, 10:32 AM
cabell's Avatar
cabell
Status: Offline
Cabell Crowther
Member
 
Join Date: Jan 2005
Location: Lynchburg, Virginia
Posts: 476
Engine Storage

I'm getting ready to remove the 2.3 petrol from the D in favor of a tdi. I intend to keep the 2.3 for installation in one of my series rigs down the road as its only done 63K and has the 5mb setup along with the revised manifolds and weber carb. How should I prepare this thing for longish term storage? Thanks!
Reply With Quote
Sponsored Links
Advertisement
 
  #2  
Old November 17th, 2008, 07:25 PM
cgalpin's Avatar
cgalpin
Status: Offline
Charles Galpin
'94 D90 ST, '63 SeriesIIA
Site Team
 
Join Date: Jan 2004
Location: South Riding, VA
Posts: 11,625
Registry
I'm no expert, but I'd venture to say clear the fuel out of the carb or any lines, squirt oil into the cylinders and re-insert the plugs, grease anything that is greasable and close/seal/grease anything that could allow air/moisture in (like the carb). Then wrap it up in pvc.

charles
Reply With Quote
  #3  
Old November 17th, 2008, 08:08 PM
evilfij's Avatar
evilfij
Status: Offline
evilfij
I have never seen a rover in person
Member
 
Join Date: Oct 2003
Location: on the internet
Posts: 14,688
Put in boat. Attach chain. Drop overboard.

Seriously, I would just fog the cylinders with oil and drain the gas and put fresh oil in it and turn it over a few times everyone once in a while. Would not hurt to leave all the oil on the outside of it to keep it from corroding

Ron
__________________
*not legal advice*
Reply With Quote
Reply

Lower Navigation
Go Back   Defender Source > Defender & Series Technical Discussions > Defender Technical Discussions

Tags
engine

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Engine Proble: Please Advise saber6 Defender Technical Discussions 24 November 6th, 2009 10:06 AM
service engine VS. check engine scubadanster Defender Technical Discussions 18 June 23rd, 2009 11:18 AM
4.0 used, complete engine dmarchand For Sale - Parts 0 September 28th, 2004 03:12 PM
Oil Info XD90 Defender Technical Discussions 5 September 7th, 2004 10:07 PM
???still can't get the trany unbolted from the engine???? kit Defender Technical Discussions 4 October 23rd, 2003 03:20 PM


All times are GMT -5. The time now is 11:57 PM.


Copyright