Bulkhead repair - Defender Source
Defender Source  

Go Back   Defender Source > Defender & Series Technical Discussions > Defender Technical Discussions

Join the Defender Source Community Today

Thread Tools
Old May 19th, 2008, 01:52 PM
61rover's Avatar
Status: Offline
John Crouse
'93 NAS D110 (#8) / '61 Series II
Join Date: Feb 2007
Location: Denver, CO
Posts: 1,097
Bulkhead repair

Has anyone had experience with a bulkhead repair panel like this? I had never seen one before. It was on ebay.uk. Seems like it would solve many of my problems. Just wondering about what it would take to fit.
Attached Images

Reply With Quote
Old May 19th, 2008, 02:33 PM
Davis's Avatar
Status: Offline
Chris Davis
94 D90, 88 RRC
Join Date: Nov 2003
Location: Colorado
Posts: 2,106
I put one on my 90. I drilled out maybe 150-200 spot welds. In the end, I would not do it again, I don't think. I was repairing my bulkhead due to a bend in a roll over accident. I would probably only replace it if it was rusted severely.
Reply With Quote

Lower Navigation
Go Back   Defender Source > Defender & Series Technical Discussions > Defender Technical Discussions

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
Removing LH wing / Fender on '83 for bulkhead footwell repair... turbodave Defender Technical Discussions 5 May 25th, 2009 03:16 PM
Bulkhead Repair Panel SafariHP The Vendors Loft 4 February 15th, 2009 07:55 AM
Drivers side bulkhead footwell repair panel for left hand drive D-90 Tyler Wirken Wanted 4 September 24th, 2008 11:26 PM
Bulkhead LH footwell repair panel? turbodave Defender Technical Discussions 1 August 22nd, 2008 02:03 PM
Help with installing bulkhead on chassis Chris Cox Defender Technical Discussions 2 June 5th, 2004 08:33 AM

All times are GMT -5. The time now is 10:42 AM.