Not a lot of updates, between snow and a lot of proposal work at work there hasn't been much opportunity. I'll say, though, that the truck was just as described and Bill was fantastic to work with.
I did get the matts and carpet installed installed for the most part and got the old exhaust removed. Need to drill the remainder of the studs out of the y pipe flange to get the new magnaflow installed. From there I'll do plugs, wires, rotor and cap for good measure and then see how emissions goes.
Got naval jelly on the very small amount of rust on the truck and will likely pull the bumpers and have them re powder coated. The good used center console will hopefully go in this weekend.
I'm seriously considering pulling the 3"+ lift with remote blingsteins and going with a 2" of some denomination to get it into the parking garage at work. If so I'll post up the old lift on here.